Dayton Model 1TDU8 Low Profile Blower 115V for Fireplace or Wood Stove (4C826)

Description

Dayton
Low Profile Blowers
not recommended for speed control
Used in fireplace inserts, woodstoves, range hoods, and more
223 CFM
3200 RPM
.39 amps
115 Volts 60/50hz
Ball Bearings
Automatic Overload Protection
Max Ambient Temp 104 Degrees F
Reference: 7021-6108, 4C826
Dayton Catalog # 1TDU8
Be sure to
compare the dimensions
listed to your unit to be sure it will fit.
The information on this page is all the info we have.
These Dayton Electric blowers / fans are sold as complete assemblies
We do not sell any parts for these units
Note: Blowers have wire leads, no power cords, plugs or switches
Note Regarding Speed Controls:
With more and more people using wood burning stoves during heating of some issues surrounding the speed controls that vary the air output from centrifugal blowers. On a single speed blower, a speed control wired in series with the hot line will allow the user to control the speed of the blower. Many speed controls will not lower voltage below 60 and will not allow the wheel to slow to 0 RPM. Also, the combination of a blower and a speed control can often result in what is called "harmonic noise" – strange vibrations and/or noises in the customer’s unit. Slightly increasing or decreasing the blower speed can sometimes eliminate this problem – but it is often not 100% removable. Care should also be used in applying solid state speed control devices, as they are often installed in the common line, or in a non-polarized plug setup. So even though the motor may not be turning because the speed control is turned too low for the motor to operate, electricity is still connected to the speed control and a potential shock hazard exists. Finally, do not use light dimmer switches as speed controls for the centrifugal blower. Controls should be approved for use with the motors found in these units.
Keep in mind that the manufactures of these blowers recommend that they not be speed controlled